HGL series disconnector

The switch adopts modular design, suitable for connecting and breaking circuit or electrical isolation, above 1000A only used for electrical isolation.

The switch adopts spring energy storage, instantaneous release accelerating closing mechanism and the contact structure with parallel double breakpoints connected and disconnected, which greatly improves the electrical and mechanical properties of the product.

The SWITCH ADOPTS GLASS FIBER REINFORCED UNSATURATED POLYESTER molding material and manual handle, which has high dielectric properties, protective ability and reliable operation safety.

Switch with 3 pole, 4 pole (3 pole + on/off neutral pole)

The front side of the switch is provided with a marking window, which is only the on-off state of the contact. The rear observation window can be provided to directly observe the on-off state of the contact, so as to ensure the reliability and safety of the switch operation.

The handle can be directly mounted on the switch for operation (referred to as in-cabinet operation), and can also be operated outside the PDC door through an extended shaft (referred to as out-of-cabinet operation), providing easy operation.

According to the need to provide normally open and normally closed auxiliary contact and installation of special floor and plate front and plate back wiring mode, to meet the needs of customers.

When the breaking position is "0", two or three locks can be used to lock the handle to prevent misoperation.